![]() Then to adjust this, turn or twist the entire inner mechanism to your desired direction (left or right). Turn to the left first and then to the right to get your fixed position. Also, the set location can be adjusted by using a screwdriver to pull up a notch located beside the inner mechanism so as to pull it all out (but not completely from the lower canister).However, be careful not to rotate the screw too far either in or out, else the nozzle or screw may come out! Screwing it out (clockwise) will increase the distance of spray and enable a larger portion of your farm to be sprayed.Note that the water pressure also affects the distance of spray as a low pressure reduces distance while a higher pressure increases the arc of spray. Take a flat head screw driver and screw it in (to the left hand side) to reduce the distance or arc of spray). Next, the distance or watering arc is adjusted using the smaller screw.To reduce the angle, you’ll turn it to the left hand side (anticlockwise) and then only a smaller portion of your garden, farm, or plantation is sprayed. Then take a flat head screw driver and turn the big screw the right hand side (clockwise) so as to make the angle bigger you’ll notice that as you turn it to the right, the angle of spray increases further.That right position is the set/lock position it is the fixed position from where sprinkling starts from which the left side is the adjusted position. To adjust the head rotation, turn the inner mechanism to the left completely and then turn it back to the right. ![]() What Are The Steps To Take While Adjusting The Head Rotation? An arrow: This lines with the nozzle and gives the location of spray.A small screw: which is used to adjust the distance of spray.A great big screw: which is used to adjust the direction in which the spray travels (left and right).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |